Dolphs Home
Dolph HomeDolph HomeDolph NewsTech TipsIndustry LinksContact Us
Product Selector
Product Guides for
Varnishes/Epoxies/Resins
Environmentally Friendly
Products
Markets Served
Technical Data
Ask Us
Data Sheets
MSDS
UL Information
Dolph USA Sales Representatives
USA / Canadian Distributors
International Manufacturing
Global Distributors
Request Information
Request for Sample
Request for Quote
Request for Lab Work
Customer Satisfaction Survey
ISO Certificate
View Request Bin

Selecting the Right Product for Your Application

Selecting the right product for your application is critical. To help you with this decision, the following table compares the properties between polybutadiene, silicone and flexible epoxies and the requirements of the electronic encapsulants. As you can see, Dolph polybutadiene systems are the right choice.

Flexible Requirements Polybutadiene Silicone Epoxy
Ease of Mixing Good Good Good
Ease of Pouring Good Good Fair to Good
Cure At Room Temperature Good Good Good
Cure At Elevated Temps Good Good Good
Primer Required No Yes No
Electrical Properties Good Good Good
Physical Properties Good Good Good
Water Absorption Good Poor Fair
Moisture Vapor Transmission Good Poor Fair
After heating to 150°C
Electrical Properties Excellent Excellent Poor
Physical Properties(a) Excellent Excellent Poor
Low temperature to -30°C
Electrical Properties Excellent Good Fair
Physical Properties(b) Excellent Poor Poor
Ease of Repair Yes Yes No
Cost Medium High Medium

(a) Resistance to thermal shock, tearing and degradation
(b) Resistance to bending and thermal shock

Some of the common terms used in MSDS's and labels


ACUTE TOXICITY - The ability of a substance to cause toxic effects which appear soon after a single exposure or dose.

AMBIENT - An encompassing atmosphere: as the ambient air.

CAA - Clean Air Act

CAS - Chemical Abstract Service

LC 50 - (Lethal Concentration 50): The concentration of a chemical substance in air or water which is expected to cause the death of half the test animal population under controlled administration.

LD 50 - (Lethal Dose 50): The dose of a chemical taken by mouth or absorbed by the skin which is expected to cause death in half the test animal population under controlled administration.

LEL - (Lower Exposure Limit): The concentration of a flammable gas or vapor in air below which a flame will not propagate if the mixture is ignited. Below this, the mixture is too "dilute" to burn or explode.

LOEL - (Lowest Observed Effect Level): The lowest dose in a controlled experiment which produced an observed effect.

MATC - (Maximum Allowable Toxicant Concentration): A term used in aquatic toxicology.

NCI - (National Cancer Institute): A part of the National Institute of Health (NIH) that studies cancer causes and prevention.

PSN - Proper Shipping Name as defined by DOT.

RCRA - Resource Conservation and Recovery Act

STEL - (Short Term Exposure Limit): Defined as the concentration to which a worker can be exposed continuously for no longer than 15 minutes up to four times a day.

>TLV - (Threshold Limit Value): Represents the air concentration of a chemical substance to which it is believed that workers may be exposed daily without adverse effect.

TWA - (Time Weighted Average): The time weighted average concentrates for a normal eight hour day and a 40 hour week, to which a worker may be exposed without adverse effects.

UEL - (Upper Exposure Limit): The highest concentration of a flammable gas or vapor in air that will propagate a flame if ignited. Above this, this mixture is too rich to burn or explode.

VOC - (Volatile Organic Compound): Any organic compound that participates in atmospheric photochemical reactions.

VOLATILE - A description of any substance that evaporates readily.

Return to Tech Tips